XTDM600

[Theoneandonlymin]

My plan is to see if I can convert this, which is a running project at the moment






Into something similar to this as I never ride off road. This bike was for sale on Ebay a few years back.



Using this which I have just bought. Using the complete front end and rear wheel.




Apparently it should go together OK. I have a bare 3TB frame that I will test assemble the parts on.

Cheers
Min

[Theoneandonlymin]

Bigger photos !!

My plan is to see if I can convert this, which is a running project at the moment






Into something similar to this as I never ride off road. This bike was for sale on Ebay a few years back.



Using this which I have just bought. Using the complete front end and rear wheel





Apparently it should go together OK. I have a bare 3TB frame that I will test assemble the parts on.

Cheers
Min

[motorang]

Das Ebay-Resultat schaut jedenfalls fesch aus. Bin gespannt.

[Theoneandonlymin]

TDM front end is a straight swap.



Cheers
Min

[Theoneandonlymin]

Rear went in OK. Just need to make up a wee spacer.

[lowrider82]

What is a wee spacer?

[derMoe]

@lowrider82
lt. Google-Übersetzer ist es ein "kleiner Abstandshalter"

@Min
Very Great Job!!
I'm looking forward to reading more about it... and pictures

Greeeets Moe

[Theoneandonlymin]

What is a wee spacer?

Small
The XT600 spacers and the brake hanger aren't quite correct. Using the XT600 caliper and brake hanger so will possibly have a disc manufactured as the TDM is of larger diameter. But that plan may change.

[Tibor]

I would try the spacer if possible. The break disk is a wear part and easier to replace when it's not custom. The spacer lives forever.

[Theoneandonlymin]

I bought a FZ600 rear disc. 220mm with correct bolt spacing. Now I need to use countersunk screes and mill my caliper a few mm.




But I have a bigger problem to solve at the moment!!!



My MG Stelvio 1200 engine swap.